Overview
Your kit will include the following items:
1 - Ornament
2 - Flat-top RGB LEDs
1 - CR2032 battery
1 - Battery holder
1 - 12" piece of ribbon
Unpack your Kit
Each kit has the following items included:
1 - Ornament
2 - Flat-top RGB LEDs
1 - CR2032 battery
1 - Battery holder
1 - 12" piece of ribbon
Place LEDs into holes
Be sure to place LEDs in same direction. The short leg (negative) should go on the left side facing the flat part of the engraved hole. The long leg (positive) should go on the right.
Ben the LED legs
Bend both of the long legs down and both of the short legs up.
Twist LED legs together
Wrap the bottom short leg around the top short leg. Then wrap the top long leg around the bottom long leg.
Attach the battery holder
Remove the insulation from the ends of the battery holder. Take the black wire and wrap around the short LED leg. Then den the leg over to secure. Take the red wire and wrap around the long LED leg. Bend to secure.
Attach the ribbon
Thread the ribbon through the hole and tie into a knot.
Insert Battery, turn on, and hang wherever you'd like!
You did it! Enjoy!
The battery holder has an ON and OFF switch.
The battery sits in the battery holder and is held in place once the battery holder is closed.
Have any questions? Contact us!